Thermal Controller, Reduced-Order Model
Application ID: 56861
Large FEM simulations can be costly and, if repeated simulations are needed, it can be beneficial to use reduced-order models (ROMs). ROMs are typically valid only in the vicinity of their design conditions and have lower accuracy, but the simulation time is significantly shorter. The objective for model reduction is to provide a sufficiently accurate representation of the input-output dynamics of the unreduced model in a given parameter range with a minimal total computational cost, including the cost of creating the reduced model.
The dynamical system consists of a metal block that exchanges heat with the exterior. Inside, there is a heater and a thermostat switch. The system works in a very simple manner: The thermostat turns the heater on and off when its temperature is too low or too high. In this tutorial model, it is illustrated how to create a reduced-order model using the Model Reduction study and how the resulting reduced model can be used to investigate different control strategies for thermal control. To illustrate the accuracy of the reduced model, a comparison with the output from the FEM model is also included.
This model example illustrates applications of this type that would nominally be built using the following products:
however, additional products may be required to completely define and model it. Furthermore, this example may also be defined and modeled using components from the following product combinations:
The combination of COMSOL® products required to model your application depends on several factors and may include boundary conditions, material properties, physics interfaces, and part libraries. Particular functionality may be common to several products. To determine the right combination of products for your modeling needs, review the Спецификация and make use of a free evaluation license. The COMSOL Sales and Support teams are available for answering any questions you may have regarding this.