Здесь представлены презентации, которые демонстрировались на конференциях COMSOL по всему миру. В презентациях рассказывается о передовых исследованиях и инновационных продуктах, созданных с помощью COMSOL Multiphysics. Исследования относятся к различным отраслям и областям применения, включая электрические, механические, гидродинамические и химические дисциплины. Чтобы найти презентации из нужной области, воспользуйтесь функцией быстрого поиска.

Numerical Evidence of Unrest-Related Electromagnetic Effects in the Campi Flegrei Caldera, Italy

G. Perillo [1], G. De Natale [2], M. G. Di Giuseppe [2], A. Troiano [2], C. Troise [2],
[1] University of Naples Parthenope, Naples, Italy
[2] INGV – Osservatorio Vesuviano, Naples, Italy

Electric, magnetic and electromagnetic (em) methods are widely used to monitor active volcanoes. A review of such applications is presented in Johnston (cit). Em signals were recorded in correspondence of numerous volcanic eruptions, for example in the case of the Mt. Unzen in Giapppone, of Merapi in Indonesia, Etna in Italy and during rapid deformation in Long Valley in California. ...

Analytical Solution for the Steady Poroelastic State under Influence of Gravity

E. Holzbecher [1],
[1] German University of Technology in Oman, Muscat, Oman

Studies of poroelastic systems increasingly utilize numerical modeling. Especially for geotechnical applications models are set up as a tool to understand phenomena in porous media that deform due to changes of the hydraulic regime, or in which the flow field is affected by changes of the stress regime. Major application fields are waste injection, CO2 injection and steam assisted gravity ...

Towards a Quantitative Prediction of Ice Forming at the Surface of Airport Runways

J. D. Wheeler [1], P. Namy [1], M. Rosa [1], L. Capobianco [1],
[1] SIMTEC, Grenoble, France

Anticipation of meteorological events such as ice forming is a key challenge to optimise the use of antifreeze on airport runways. To obtain a predictive numerical tool of ice forming on the runways, Groupe ADP and SIMTEC developed a COMSOL Multiphysics® model, in which several physical phenomena contributing to the temperature variations of the runway are involved. Radiative exchanges occur ...

Analysis of Multiphysics Problems Related to Energy Piles

E. Evgin[1], J.A.I. Sedano [1], Z. Fu[1]
[1]University of Ottawa, Ottawa, ON, Canada

Energy piles transfer the mechanical loads from buildings to the ground and serve as heat exchangers. Temperature changes in the ground influence its moisture content. This paper examines the effect of soil moisture content on the shaft resistance of a pile. Tests were carried out in the laboratory to determine the mechanical properties of an interface corresponding to various soil moisture ...

Electromagnetic Field Computations for Saturated Porous Media

S. Cambon[1], I. Bogdanov[1]
[1]CHLOE, Bâtiment UFR Sciences et Techniques, Pau Cedex, France

Non-conventional hydrocarbon resources become more and more challenging object for energy producing companies throughout the world. Being already known and long-explored method, the electromagnetically (EM) assisted recovery constitutes a promising idea of technology for deposits of such a kind. COMSOL has been used recently for modeling the thermal multiphase flow through porous media in the ...

Safe Storage Parameters During CO2 Injection Using Coupled Reservoir-Geomechanical Analysis

T.I. Bjørnarå[1], E. Aker[1], and E. Skurtveit[1]
[1]NGI, Oslo, Norway

Safe short term storage of CO2 depends mainly on structural and solubility trapping. On longer term, mineral trapping is also contributing to the trapping of CO2. To be able to investigate the importance of these different storage mechanisms, a finite element model for simulation of CO2 injection has been developed in COMSOL Multiphysics®. The model describes and solves for two-phase flow ...

Building a Robust Numerical Model for Mass Transport Through Complex Porous Media

J. Perko[1], D. Mallants[1], E. Vermariën[2], and W. Cool[2]
[1]Belgian Nuclear Research Centre (SCK-CEN), Mol, Belgium
[2]Belgian Agency for Radioactive Waste and Enriched Fissile Material (ONDRAF/NIRAS), Mol, Belgium

Mass transport modelling through porous media is typically characterized by complex physics and geometry. In the particular case of radionuclide transport, modelling for radioactive waste repositories, an additional level of complexity, and thus uncertainty, originates from the long time frames involved. Performing a safety analysis of a radioactive waste disposal system requires therefore ...

Coupled Gas Flow and Thermal and Reactive Transport in Porous Media for Simulating Waste Stabilization Phenomena in Semi-Aerobic Landfill

H. Ishimori, K. Endo, T. Ishigaki, H. Sakanakura, and M. Yamada
National Institute for Environmental Studies
Tsukuba, Ibaraki

Semi-aerobic landfill has interesting structure that passively provides the atmospheric oxygen into landfilled waste due to the heat convection generated by the decomposition of landfilled waste. There are limited studies on the mechanisms of the oxygen transport. This paper presents the governing equations and parameter estimation methods for the numerical simulation of the gas fluid flow and ...

Ability of Single-Well Injection-Withdrawal Experiments to Estimate Ground Water Velocity

F. Maier[1], K. Hebig[2], Y. Jin[1], and E. Holzbecher[1]
[1]Georg-August Universität Göttingen, Göttingen, Germany
[2]Technical University Berlin, Berlin, Germany

The authors present a closer look on the Single-Well Injection-Withdrawal Experiment (SWIW) or Push-Pull Experiments and its ability to determine the groundwater velocity, as one of the major parameters concerning reservoir management and underground reservoir characterization. The flow field is modeled using analytic and numerical solutions. Different modes like Darcy-law, solute-transport and ...

Elasto-Plastic FEM Models Explain the Emplacement of Shallow Magma Intrusions in Volcanic Complexes

A. Bistacchi[1]
[1]Università degli Studi di Milano Bicocca, Milano, Italy

We present numerical models and field data that aid understanding of volcano-tectonic processes related to the propagation of inclined sheets and dykes under a stress field resulting from the inflation of a shallow magma chamber. Structural field data from the classical Cuillins cone-sheet complex (Isle of Skye) show that sheets have a constant average dip angle (45°), with pure dilational or ...