Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Geometry optimization

Please login with a confirmed email address before reporting spam

Hello everyone, I´m modeling a simple heat transfer - structural problem, wher I have a 2-D rectangle with a hole in the midle. First I apply a Temperature load that produces expansion in the structural analysis. Then I apply a pressure
in the top of the rectangle.

This combination gives me a stress result in my model. What I want to do is to find the optimum thickness in my rectangle (variable in x and y) that make that the stress in any point in the rectangle does not overcome some specific
value. Other restriction in the model is that the thicknes variable can´t pass under a minimum thickness d_min.

I want to know if i cant fin this optimal d variable with the optimization module and how to do it. I´m trying
with global objetive = abs(solid.sy-sigma_max), and in control global variable I have d as the control variable, and
d_min as my initial value.

Thank you for your help.

1 Reply Last Post Oct 18, 2012, 11:08 a.m. EDT
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Oct 18, 2012, 11:08 a.m. EDT
Hi

I believe that is what COMSOL and the optimisation module is here for ;)
Take a look at the model library examples.

In fact you should be able to do a simple 1 variable optimisation even without the "optimisation" module, but if you have it, you will gain time and have less equations to write out

--
Good luck
Ivar
Hi I believe that is what COMSOL and the optimisation module is here for ;) Take a look at the model library examples. In fact you should be able to do a simple 1 variable optimisation even without the "optimisation" module, but if you have it, you will gain time and have less equations to write out -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.