Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Inverted mesh point at a point wher virtually nothing is going on.

Please login with a confirmed email address before reporting spam

So I am getting this warning,

Warning: Inverted mesh element near coordinates (-2.84755e-025, -4.9111e-011),

While I am using a very small model of a tube basically with dimentions 100nmx100um, the point mentioned above is in the middle of a area where nothing of importance is happenening and should be essentially at steady state. I would better define the mesh at that area but that I dont think is the problem.

I am modeling electrodeposition in a nano pore so it may and am basically following the copper deposition model with a few minor changes. Any suggestions would be appreciated.

Thank

0 Replies Last Post May 6, 2012, 7:05 p.m. EDT
COMSOL Moderator

Hello Matt Hein

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.