Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Plot the change of a variable over the whole simulation time in one point
Posted Jan 19, 2012, 8:35 a.m. EST Geometry, Results & Visualization Version 4.2 1 Reply
Please login with a confirmed email address before reporting spam
Hey guys,
I have an easy problem, buts its hard for me to solve...
I want to plot then change of a variable (temperature, pressure and so on...) over the whole simulation time in one specific point of my choice of my geometry.
The problem is to tell Comsol, which specific point I likte to have. How can I do this?
Without any problems it is possible to plot the status of all points for a specific timepoint. I do not want to though. Can someone help me there?
Greetings
I have an easy problem, buts its hard for me to solve...
I want to plot then change of a variable (temperature, pressure and so on...) over the whole simulation time in one specific point of my choice of my geometry.
The problem is to tell Comsol, which specific point I likte to have. How can I do this?
Without any problems it is possible to plot the status of all points for a specific timepoint. I do not want to though. Can someone help me there?
Greetings
1 Reply Last Post Jan 19, 2012, 9:14 a.m. EST
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
either the point, line, boundary exist, and you can integrate or average over this element in a derived variable, that makes a table over time, and then you plot that
if the element does not already exist in the geometry, you need to make a derived data set (point, line cut plane ...) from the solution data set and then plot there on
--
Good luck
Ivar
either the point, line, boundary exist, and you can integrate or average over this element in a derived variable, that makes a table over time, and then you plot that
if the element does not already exist in the geometry, you need to make a derived data set (point, line cut plane ...) from the solution data set and then plot there on
--
Good luck
Ivar