Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

error message from RESULTS options -unexpected error

Please login with a confirmed email address before reporting spam



Hi

A model runs OK and then when I hit a result node like an EDGE or a CUT POINT I get this annoying pop up window

with the message: An unexpected error occured see the end of logfile for details.

I can either press OK or "open log file" or close the error message but of course it pops up again.

If I open the log file I can't understand anything there.

The node remains inaccessible , is there any way to avoid this?

thanks

David


0 Replies Last Post Jan 4, 2012, 3:56 p.m. EST
COMSOL Moderator

Hello David Segal

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.