Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to change the range of values in the legend bar?

Amin Hassanzadehbarforoushi

Please login with a confirmed email address before reporting spam

Hello world,

I am looking for a method to change the range of values on the legend bar.

I did simulations of a mebrane deflection under different loads and computed for the von mises stress (also see the attached image). Looking into the results, each of them are reporting different range of stress which is quite natural. However, I want to make a big figure in which I put all of the simulations results with only one legend bar (to compare them together).

I would appreciate any kind of idea/solutions. Thanks!

Kind regards, Amin



0 Replies Last Post Jan 16, 2019, 8:43 p.m. EST
COMSOL Moderator

Hello Amin Hassanzadehbarforoushi

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.