Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Thin layer in Heat transfer module

Please login with a confirmed email address before reporting spam

Hi,
I am working on 3D shell and tube heat exchanger. If I use thin layer feature in heat transfer module for the walls, then do I have to draw the tubes using inside diameter or outside diameter of the tube?

In the application library model, tubes of diameter 15mm are drawn. Is this the inside or outside diameter of the tube?

0 Replies Last Post Nov 5, 2016, 11:01 a.m. EDT
COMSOL Moderator

Hello Asif Ahmed

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.