Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Shorting a coil and applying current

Please login with a confirmed email address before reporting spam

I want a shorted circular coil of 4 turns made of copper material. I am also applyng a ac current of 2A, 10Khz frequency to the coil. As it is not possible to physically join the two ends of coil in comsol, I want to know any other alternative to do the same.

Is it possible to give Voltage=0V and current = 2A,10Khz in the same coil ? If possible on comsol, please give me steps to do it?

Please find the attached image to see how i have done?

i am using comsol 5.5 version.



0 Replies Last Post Jul 5, 2020, 10:18 a.m. EDT
COMSOL Moderator

Hello Shilpa George

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.