Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Extruding a 2-D Geometry / Bullnose Creation

Posted May 19, 2010, 6:29 p.m. EDT 0 Replies

Markthomas Cutone
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello all,

I am performing a simulation of turbulent flow over a flat plate with a blunt leading and trailing edge. I would like to add a rounded nose to this plate and make it a 3-D problem by extruding it.

My Procedure:

Create the plate rectangle (2-D)
Draw the circle in the correct location at the leading edge (2-D) -- *****the radius of the circle is 0.000635 m******
extrude a distance of 1 for example

When I do this the circle becomes a square cylinder!! How can I work around this issue?

Thanks

Markthomas
0 Replies Last Post May 19, 2010, 6:29 p.m. EDT
COMSOL Moderator

Hello Markthomas Cutone

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content