Boundary not applicable

Please login with a confirmed email address before reporting spam

Hello everyone,

I'm sorry, I'm new to COMSOL and I'm quite sure that this issue has been covered already in the forum, but I cannot figure out how to tackle it in my model. I have a simple stack of two squares and I would like to set a surface reaction at the boundary between the two squares using the tds physics. But for some reasons the boundary between the two geometries is not applicable. Please find attached the file to have a clearer idea.

Any suggestion on how to proceed? Thank you!



0 Replies Last Post Nov 25, 2023, 2:55 p.m. EST
COMSOL Moderator

Hello Andrea R.

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.