Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Push and pull auxiliary sweep

Please login with a confirmed email address before reporting spam

Hi,

I try to model corrugated cardboard, to be precise I wish to model the creasing and scoring of corrugated cardboard. The creaser needs to be pushed and pulled back up to see plastic deformation on the board.

I use an auxiliary sweep, with a displacement as parameter, to crease to board, however the creaser has to be pulled back up again. How can I do that, such that the creaser and the board are not in contact with each other anymore? Is that plastic deformation shown immediately?

For the board I use a Orthotropic model, since the board experience different strenght properties in the three mutual directions. Under 'Linear Elastic Material' I added a plasticity model based on Hill orthotropic plasticity.

Thanks in advance!



0 Replies Last Post Oct 1, 2021, 6:59 a.m. EDT
COMSOL Moderator

Hello Niels Visser

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.